Farms.com Home   Expert Commentary

Consider SCN Sampling This Spring

May 02, 2017
By Connie Strunk
SDSU Extension Plant Pathology Field Specialist
 
Segment of soybean root infected with soybean cyst nematode.
 
Soybean Cyst Nematode: Crop impact
 
Soybean cyst nematode (SCN) silently robs significant soybean yield without displaying obvious above ground symptoms. Unfortunately, when SCN is introduced in the field, it can never be completely eliminated; however, SCN can be managed to keep SCN population below injury level. By the time one soybean cyst is observed on the soybean roots or in the soil sample, likely more cysts are occurring in that field. One cyst can contain up to 300 eggs, and 2-3 cyst cycles can occur in a growing season.
 
Management
 
SCN management starts with a soil test to determine the presence or absence of this nematode in the soil. Absence may indicate that either the soybean cyst nematode has not established in the field or it could be present at non-detectable levels. Therefore, there is a need to keep testing the soil every so often (recommended every three years). A positive SCN detection requires adoption of an integrated management approach that includes planting resistant cultivars, crop rotation with non-hosts, and use of nematicide seed treatments especially for fields where SCN egg counts are very high (>10,000 eggs/100 cc of soil). It should be noted that the effectiveness of nematicide seed treatments has not been consistent across the region.
 
Sampling Soil for SCN
 
When to Sample
 
Soil sampling for SCN can occur at any time throughout the year as long as the soil is not completely saturated or frozen. If you were unable to get your fields sampled for SCN this fall, consider sampling this spring.
 
Areas to Target When Sampling
 
Areas to target and sample include: field entrance, along fence lines, low spots, previously flooded areas, waterfowl activity areas, high pH areas, and low yielding/stunted areas of the field.
 
How to Sample
 
Collect 20 soil cores 0-6” deep in a zig-zag pattern using a soil probe (Figure 1) or a spade. The soil cores should be thoroughly mixed and put in a soil sample bag or plastic bag (only about a pint is needed for testing). Larger fields should be divided into smaller 10-20 acre field portions, and each portion sampled separately.
Click here to see more...