Farms.com Home   News

Soil Nitrogen Management Following 2016 Crop.

By Emerson Nafziger
 
The 2016 growing season has been a very good one for corn in Illinois, with the November yield estimate of 202 bushels per acre, slightly higher than our previous best of 200 bushels per acre in 2014.
 
In sharp contrast to the wet June of 2015, most of Illinois received below-normal rainfall in June 2016, with parts of western and southwestern Illinois receiving less than an inch for the month. With May rainfall close to normal across the state in 2016, the wet soils and N loss conditions that we saw over most of Illinois in 2015 never materialized in 2016.
 
2016 Nitrogen Rate Studies – N Timing and Uptake
 
In our N-tracking project funded by the fertilizer assessment (Nutrient Research & Education Council), we apply 200 lb. of nitrogen per acre as fall-applied ammonia, early spring-applied ammonia, fall ammonia plus spring-split UAN, or spring-split UAN. We then sample during the spring to see how much N remains in the top 2 feet of soil.
 
Averaged over three locations in 2015, sampling in mid-June and at tasseling recovered about 70 and 42 percent, respectively, of the amount of N applied as fertilizer. In 2016, we found a little more N than this –about 76 percent in mid-June and 47 percent at tasseling. Grain yield levels didn’t differ greatly between the two years, but more of the N needed by the crop was taken up by tasseling in 2016 compared to 2015. Yields were similar in both years, though, so having more N taken up by tasseling did not clearly lead to higher yields.
 
Warm soils and wet weather in December 2015 caused a lot of concern about loss of fall-applied N in 2016. But we did not find lower amounts of soil N following fall N applications than we found following spring applications in 2016. There were, however, some differences between the two years in how much of the N recovered was in the ammonium form (coming directly from ammonia application) and how much was nitrate. Nitrate can move in the soil and be lost.
 
In both 2015 and 2016, about 80 percent of the N recovered in early May following fall ammonia application was nitrate. Following spring ammonia application, 59 percent of the nitrogen was nitrate in 2015, while in 2016 only 39 percent was nitrate. By early June, when N uptake by plants began, 80 to 90 percent of the recovered N was nitrate in both years, regardless of timing of application.
 
It’s clear from these numbers that applying ammonia in the fall versus spring did not have much effect on how well the nitrogen was protected by remaining in the ammonium form, at least by the time N uptake began. This suggests that N loss is tied more closely to conditions during N uptake (June) than to N fertilizer timing, although sidedressing ammonia, which we did not do in this study, would have increased the amount present as ammonium.
 
Most N rate trials in 2016 show yields leveling off at considerably lower N rates than in 2015. This year we’re often seeing yields leveling off at N rates of only 140 to 160 lb. N per acre, at yield levels between 200 and 250 bushels per acre. We think that this speaks both to a large supply of N from mineralization of soil organic matter under the favorable conditions of May and June, and to the drier conditions this year that limited N loss and root damage. Another sign of a good supply of N from the soil was the delay in development of N deficiency symptoms in corn grown without fertilizer N. It was common in 2016 to see unfertilized corn as dark green as fertilized corn in mid-June, when the crop was 3 feet tall or taller.
 
Nitrogen in the Soil
 
One might expect that less N loss might lead to higher amounts of N left over at the end of the season. We aren’t seeing this in most cases. Dan Schaefer of IFCA took soil samples at the time of crop maturity at a number of on-farm sites, nearly all of these showed soil N levels of less than 6 or 7 ppm, which we consider to be baseline levels. We’re also finding low soil N levels in samples taken following harvest in our N-tracking trials. The only place we’re seeing elevated levels is at N rates considerably higher than those needed to maximize yield. Using too much N is never a good idea, and that was especially true in 2016.
 
Those who added N late in late vegetative stages this year in addition to normal rates applied earlier might well have ended up with more soil N than usual after harvest. A vigorous cover crop like cereal rye will take some of this up. But the low levels of soil N in fields with normal rates of fertilizer N may not have enough N to produce vigorous cover crop growth. Trying to “prime” cover crop growth by applying fertilizer N this fall will increase N uptake, but may not necessarily increase net uptake after subtracting the amount applied.
 
Despite slow cooling at the start of November this year, soil temperatures are now below 50 degrees over most of northern and central Illinois, and ammonia application is underway. Soils are mostly in good shape for this, but application should be delayed in fields with wet surface soils .
 
Nitrogen Management Considerations for the 2017 Crop
 
We can think of no good reason to adjust N rates, unless planned rates are substantially higher that the 175 (155 in northern Illinois) and 210 lb. N per acre or so calculated by the N rate calculator for corn following soybeans and corn following corn, respectively, in the region of Illinois where fall N is used. If planned rates are higher than this, a downward adjustment is in order.
 
If the plan is to apply some N in the spring after fall application, consider subtracting that amount from the fall application rate in order not to exceed the suggested rate. If 2017 is like 2016 with regard to N nutrition, using more than suggested rates will nothing to increase yields, but will increase both economic and environmental costs.
 
There’s been a lot of talk the last few years about how CEC “limits” the amount of N that should be applied to a given soil; the maximum amount commonly mentioned is 10 lb. N per unit of CEC. CEC is “charge density” – the concentration of negatively-charged exchange sites in a soil. Soils with more clay and more organic matter have higher CECs; silt loam or silty clay loam soils with 3 or 4 percent organic matter typically have CEC values of 20 to 40 or so.
 
That’s more than enough to “hold” applied N, but there’s no sound basis for considering CEC a measure of “N-holding capacity,” any more than it is to consider it as potash- or calcium-holding capacity. One unit of CEC will hold 360 lb. of ammonium-N in the topsoil. But ammonia applied to soil dissolves instantly in soil water, then converts quickly to ammonium. Like any positively-charged ion (cation) in the soil solution, ammonium ions quickly occupy (negatively-charged) exchange sites. And, like other cations, ammonium does not move down in most soils, or certainly not down very far, regardless of the amount applied (within reason.) A possible exception is light, sandy soils, but N should not be applied in the fall in such soils in any case.
 
So base N rates on the N rate calculator, which is based on research showing what rate can be expected to maximize profit, and apply at a time and in a form to minimize N loss. Don’t worry about the CEC value.
 

Trending Video

Top Tips on Corteva Agriscience’s Enlist Weed Control in Corn

Video: Top Tips on Corteva Agriscience’s Enlist Weed Control in Corn

During this Seed World Visits interview, Corteva Agriscience’s Enlist Field Specialist Tony Goede explains the Enlist Weed Control System, including how to tackle weed resistance, the differences between Enlist corn and Enlist E3 soybeans, and why farmers shouldn’t (and can’t) use generic 2,4-D with Enlist crops.