NDSU Extension Offers Guidance Amidst Power Outages and Flooding

May 02, 2022

As snowstorms, power outages and flooding impact much of the state, North Dakota State University Extension offers guidance to help North Dakotans stay safe and take steps to prevent further disasters.

flooding

Flooding and power outages are causing challenges across the state. (NDSU photo)

Stand-by Generators

With widespread power outages, many people are relying on stand-by generators. NDSU Extension agricultural engineer Ken Hellevang reminds people that generators should remain outdoors.

“Carbon Monoxide poisoning is common after disasters due to the generator being in a building, even with the door open,” says Hellevang. “Do not connect the generator to a home or farm electrical system without a transfer switch that disconnects the farm or home from the power line and connects to the generator. The wiring system must be isolated from the power lines using a double-throw transfer switch to prevent the generator from feeding electricity back into the power line.”

Additionally, Hellevang advises people to ensure that the generator matches the electrical load and only supplies power to the desired circuits.

“As a guide, electric motors require approximately 4,000 watts of power to start and 1,000 watts of power to run for every horsepower of output,” says Hellevang. “A typical home operating a water pump, refrigerator, freezer, furnace blower (gas furnace) and a few lights will require about 5,000 watts of peak usage for starting and 2,000 watts for continuous operation. Sum the wattage of each light, refrigerator motor and furnace blower to determine what the generator can power.”

“If using extension cords, assure that the wire is the appropriate size for the wattage,” says Hellevang. “A motor will ‘burn-out’ if the wire is too small or a long cord is used due to voltage loss in long cords or wires.”

Flooding

Hellevang also offers guidance for those dealing with spring flooding.

“Flooding can cause washouts and severe erosion,” says Hellevang. “Be very careful in navigating during and after flooding.”

Hellevang advises farmers and ranchers take several key steps during and after flooding.

Examine farm buildings for any movement from alignment.
Test the water of any wells that have been flooded before using.
Check grain bins for any stretching of bolt holes if the grain got wet.
Watch for signs of flood-related diseases in livestock, such as lameness, fever, difficulty breathing, muscle contractions or swelling of the shoulders, chest, back, neck or throat.

Basement seepage is another common problem with saturated soil and flooding.

“Remove wet porous materials or dry completely within a couple days to limit mold growth,” says Hellevang. “Most carpets require airflow on both sides to adequately dry.”

Hellevang adds that a ground-fault circuit interrupter must be used with all electrical use in a wet environment to prevent electrocution.

Source : ndsu.edu

Video: Swine Industry Advances: Biodigesters Lower Emissions and Increase Profits

Analysis of greenhouse gas (GHG emissions) in the Canadian swine sector found that CH4 emissions from manure were the largest contributor to the overall emissions, followed by emissions from energy use and crop production.

This innovative project, "Improving Swine Manure-Digestate Management Practices Towards Carbon Neutrality With Net Zero Emission Concepts," from Dr. Rajinikanth Rajagopal, under Swine Cluster 4, seeks to develop strategies to mitigate greenhouse gas emissions.

While the management of manure can be very demanding and expensive for swine operations, it can also be viewed as an opportunity for GHG mitigation, as manure storage is an emission source built and managed by swine producers. Moreover, the majority of CH4 emissions from manure occur during a short period of time in the summer, which can potentially be mitigated with targeted intervention.

In tandem with understanding baseline emissions, Dr. Rajagopal's work focuses on evaluating emission mitigation options. Manure additives have the potential of reducing manure methane emissions. Additives can be deployed relatively quickly, enabling near-term emission reductions while biodigesters are being built. Furthermore, additives can be a long-term solution at farms where biogas is not feasible (e.g., when it’s too far from a central digester). Similarly, after biodigestion, additives can also be used to further reduce emissions from storage to minimize the carbon intensity of the bioenergy.