By Denise Attaway
Growing season is in full swing and farmers must pay close attention to the water needs of several crops at this stage, says a Clemson University specialist.
“Some areas, especially in the Pee Dee region, have experienced excessive rainfall that affected planting, replants and field work over the last few months,” Plumblee said. “Throughout the state, certain areas are beginning to become dry and run out of moisture. Several irrigation systems have been running to maintain crop yield potential.”
“Statewide, the majority our corn crop seems to be on track to produce good yield,” Plumblee said. “However, it is important growers remember to use irrigation, if available, to finish out their crops as needed.”
A majority of cotton in South Carolina was planted later than normal. Depending on the weather, cotton planting usually begins in late April and continues through May in the state. Michael Jones, Clemson Extension cotton specialist
housed at the Pee Dee REC, said wet, cold conditions in early May set back planting. USDA reports
show 69% of the state’s cotton crop was squaring and 14% was setting bolls as of July 19.
“As we transition into bloom and reproductive growth, water use in cotton is increasing rapidly,” Plumblee said. “To maximize yield, it is important growers make sure adequate soil moisture is available to plants going into and throughout bloom and boll fill.”
As crops transition into reproductive growth (bloom) stage, water use begins to increase rapidly. At the beginning of bloom, cotton, peanut and soybean crops use approximately 0.2 to 0.25 inches of water per day. In the absence of rainfall, roughly 1 inch of irrigation should be applied every 4 days to replace losses that occur due to evapotranspiration, or the loss of moisture caused by evaporation of water from the soil and transpiration from plants. Water use continues to increase until peak bloom in cotton and peanuts and the R2-R3 (full bloom to beginning of pod development) growth stage in soybeans.
Plumblee said using soil moisture sensors for irrigation scheduling and knowing crop water use by crop growth stage is important to ensure crops have enough water to be productive. Soil tension and volumetric are the two most common types of soil moisture sensors used for scheduling irrigation. Depending on which type of sensor a producer may be using, threshold values or threshold units may vary. Typical recommendations place threshold values between 25% and 50% maximum allowable depletion, which means 25% to 50% of water available to plants in the soil is allowed to deplete before recharging with irrigation.
Ongoing research being conducted at the Edisto REC using soil tension sensors and funded by the S.C. Water Resources Institute suggests a weighted average threshold of -30 kPa (cbar) in the top 24 inches of soil may provide the best net return for growers in cotton where soil moisture sensors are being used. Additional research is being conducted this year to refine season-long thresholds in soybeans.
Source : clemson.edu